VideoWave n-Eye Guide d'installation télécharger pdf (Page 11)

PHYSICAL SETUP

Tab 6, 14 Tab 8,16Tab 7, 15English Tab 5, 13Tab4, 12Tab 3, 11Tab 2, 10

7. Route both cords through the leg of the stand and

re-attach the connector cover.

8. Plug the AC power cord from the monitor into a live

AC (mains) outlet.

9. Go to “Control console placement and connec-

tions” on page 15 to continue the physical setup.

CAUTION: Bose strongly recommends installing the

two included anti-tip straps that, when properly installed,

provide an extra measure of security in the event that the

monitor accidentally starts to tip over.

Installing the anti-tip straps

It is important that you install both straps according to

the following instructions.

WARNING: Do not use the anti-tip straps for any

application other than the one specified in this setup

guide.

CAUTION: If you are unsure of the construction methods

used in your home, or if you do not understand these

instructions or have any concerns or questions, please

contact a professional installer.

1. Using the provided 5/32 in. (4 mm) hex wrench,

remove the top two bolts from the rear panel of the

monitor as indicated.

Leg of stand

Bolts to

remove

00.Marley_Setup.book Page 11 Tuesday, January 10, 2012 8:47 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

VideoWave n-Eye Guide d'installation Page 11