VideoWave n-Eye Guide d'installation télécharger pdf (Page 11)

PHYSICAL SETUP

Tab 6, 14 Tab 8,16Tab 7, 15English Tab 5, 13Tab4, 12Tab 3, 11Tab 2, 10

1. Using a 5/32" (4 mm) T-handle hex wrench (not

included), remove the top two bolts from the rear

panel of the monitor as indicated.

2. Using the same bolts, attach the two straps to the

back of the monitor as shown.

CAUTION: The included screws are for use only into

wood-studded wall constructions with one-inch (max.)

drywall. For all other types of wall construction, please

contact a professional installer. Use caution to avoid any

electrical or plumbing lines running through the studs.

3. Locate the two wall studs closest to the straps.

Each strap should be attached to the wall stud

closest to it.

DO NOT attach both straps to the same stud.

4. Hold the bracket on the end of each strap against

the wall 18-24 inches (46-61 cm) above the

tabletop. In the center of each wall stud, mark

the location of the two holes in the bracket.

Bolts to

remove

Tabletop

18"

(46 cm)

24"

(61 cm)

00.Marley_Setup.book Page 11 Monday, November 8, 2010 11:04 AM

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 19 20

Pas de commentaire

VideoWave n-Eye Guide d'installation Page 11